Real Good Toys Victorian Painted Lady Instructions Manual page 17

Instructions for kit #JM-4600
□
23. Lay out a set of Bay Walls for the Base;
one 4 3 / Front with a groove at the bottom, one 3
4
with a groove at the bottom, and one 3
groove (it's the same as the "Top Bay Walls").
Line them up at the top (check the clapboard on the one
with no groove) and tape across the face leaving a 4" flap
on both ends.
Turn the Bay Walls over, spread glue on all the beveled
ends, in the grooves, and on the bottom edge of the un-
grooved wall.
Install and tightly tape the Bay Wall set to the house.
(Illustration #21B)
Repeat for the Bay Wall set on the other side of the Base.
□
24. Glue a Bay Vertical, Side to the front edge of each Side
Wall and the top of the Base Bay Wall, lined up on the inside.
Repeat for the Inset Walls... 4 Bay Vertical Sides.
Note: the point of the Bay Verticals and Bay Walls
that sticks out will rest against Stripwood that will
be installed in Step 60
3
3 / Side with no
4
A final check of the Bay Walls' position:

Hold the Porch Cornice between the Bay
Walls. When it lines up at the back edge,
the walls are perfect
Illus. #21A
/ Side Base Bay Wall set for the right side
4
Base Bay Wall set for the left side
Keep the outside point
the same all the way
up the house
Walls and Floors (1) page 17
Tape
Illus. #21B
Right Bay Wall set
The edge of the Bay
Wall is wider than the
Inset Wall. Line it up
on the inside
Lined up in back
Porch Cornice
Illustration #24
Side Wall or Inset Wall
Bay Vertical Lined up on the inside
Lines up on the inside
with the Base Bay Wall
Keep it tight on
the corner
Illus. #21C