Instructions for kit #JM-4600
Inspect the floor at the back of the Dividers
and Side Walls to be sure nothing has moved
□
18. Glue the other Front Set to the Mid Floor,
lined up in front and centered side-to-side. Press
down, clean up the glue squeezings, then add weight
while the glue dries. Confirm the front-to-back fit
with the Dividers and the side-to-side fit with the
Front Spacers.
Let the glue dry
□
19. Tape the Dividers to the back of the Front set
and to the back edge of the Mid Floor to hold the Front
Set straight. Tape the Front Spacers between the top of the
Inset Walls and the Side Walls, just-below the grooves for
the Top Floor.
Apply glue to the top of the Front Set and to the ends of
the Top Floor (NOT on the Dividers or Front Spacers).
Put the Top Floor in place, lined up with the Sides in back,
with the Dividers in back, and with the Front Set in front.
Use the "front-to-back tape" technique to hold the inspec-
tion points (Illustration #17B) while the glue dries.
Tape the Top Floor tightly to the Sides and put weight
over the Front Set. Let the glue dry (Illustration #19B)
Visit www.dhbuilder.com for more assembly photos
Front Spacer
Illus. #19A
Illus. #19B
Top Floor
Floors and Walls (1) page 15
Dividers
TEMPORARY
Front Set
Front Spacer
Lined up
Dividers
Front Spacer
Let the Glue dry