Real Good Toys Victorian Painted Lady Instructions Manual page 16

Instructions for kit #JM-4600
Inspect the floor at the back of the Dividers
and Side Walls to be sure nothing has moved
□
20. Glue and tape the Gable Floor (8
the Top Floor lined up on the right with the outside of
the Right Side Wall. Extend a Divider under the Gable
Floor for support as the glue dries.
Let the glue dry
□
21. Identify "up-and-down" for the Attic Front
The Attic Front is an odd-shaped part, and builders of-
ten think the square edge (in the upper right in the photo)
should go down... but if you start with the Gable Triangle in
place (Illustration 23), it's easier to make the Attic Front fit
□
22. Without glue, tape together the Attic Front and the
Gable Triangle (Illustration #23).
Glue the Attic Front to the Top Floor with the Gable Tri-
angle lined up with the edges of the Gable Floor side-to-side
and with the Attic Front lined up with the front edge of the
Top Floor. Don't glue the Gable Triangle; it's only here to
locate the Attic Front side-to-side, and it will be removed.
Let the glue dry
1 / x 3 3 / ) to
2 8
Bay Vertical, Side
Lined up in front
Walls and Floors (1) page 16
Illus. #20
Gable Floor
Divider for support
Don't glue the Divider here!
Attic Front
This photo shows parts that
have not been installed yet.
Illus. #23
Attic Front

Lined up side-to-side
Any flat panel
makes it easier to
line up the outside
Attic Divider holds
the Attic Front
straight
Gable Triangle
(temporary)