Page 2
Networks warrants that software will operate substantially in accordance with its functional specifications for 90 days and that it has been properly recorded on non-defective media. Fluke Networks does not warrant that software will be error free or operate without interruption.
Taiwan: (886) 2-227-83199 authorized personnel for line testing and temporary • USA: 1-800-283-5853 communications. Specifications herein apply to TS22 and TS22A models, unless otherwise noted. • Anywhere in the world: +1-425-446-4519 Visit our website for a complete list of phone numbers. Registration...
TS22 Series Craft Test Sets Users Guide • Safety Information Try connecting to another working pair. The TS22 Series Test Sets are designed to resist Radio The following IEC symbols are used either on the test Frequency Interference (RFI). If RFI is encountered set or in the manual: during the operation, take the following steps to minimize the effects:...
3 V lithium battery. Line Cords The TS22 and TS22A Test Sets have a replaceable 9 V The test set has a field replaceable line cord; however, if (alkaline) battery that powers the speaker. If the the replacement cord is not installed properly, the battery is low, only the speaker should be affected.
MONITOR mode. The SPEAKER button controls the volume of the amplified speaker. The speaker has three volume levels TS22A DataSafe™ Feature (low, medium, and high). TheTS22A Test Set is designed to Bellcore Technical Note Reference TR-TSY-000344. The high impedance...
On the TS22A, the M position provides a high impedance coupling, which allows line monitoring without disrupting conversations or signaling. MUTE On the TS22A, pressing the MUTE button turns off the speakerphone microphone for privacy. On button the TS22, it disables the amplified speaker.
TS22 Series Craft Test Sets Users Guide Keypad Controls and Indicators Figure 4 describes the keys, controls, and indicators in the keypad area of the TS22 test sets. bfs04.eps Numeric The numeric keypad is used to dial telephone numbers and make function selections. The ∗...
Operation Operation TS22A Speaker Monitor Mode To put the TS22A Test Set into speaker monitor mode: TS22 Amplified Speaker Mode Set the TALK/MONITOR switch to M, then press the SPEAKER button once to enter speaker mode To put the TS22 Test Set into amplified speaker mode: with low volume.
Dialer) Connect the test set to the line and receive dial tone. The TS22 and TS22A Test Sets have 9 memory locations, which correspond to number keys 1 through 9. Each Dial the number. location will store up to 18 digits. If a nineteenth digit is...
To locate a short circuit, open one side of the line chlorinated solvent on the test set. Doing so and place the TS22 or TS22A Test Set in the loop – will damage the test set. one test lead to each side of the opened line. On the Central Office (CO) side of the fault, a loud CLICK will be heard;...
The belt clip assembly is field replaceable in the event To replace the battery (see Figure 5): of damage or prolonged wear. To order a replacement belt clip, contact your local Fluke Networks authorized Disconnect the test set from the line and place on distributor.
Power Source continuous use, typical Speaker Levels for Low, medium, high and off TS22 Automatic Power After 5 min. of no audio signal Shut Off Speakerphone Low, medium, high and off Levels TS22A Power Source Shared line and battery power...
Page 16
TS22 Series Craft Test Sets Users Guide...