Dahua Network Camera Web 3.0 Operation Manual page 61

Dahua Network Camera Web 3.0 Operation Manual
Enable
ARP/Ping set
device IP
address service.
5.2.1.1 Easy4ip
Click "Enable" to connect the device to network, and then you can connect to the device via mobile
client of Easy4ip after "Online" is displayed on the interface (connection mode: add device serial number
or scan QR code). See
You can use ARP/Ping command to modify or set the device IP
address if you know the device MAC address.
Before the operation, please make sure the network camera
and the PC in the same LAN. This function is on by default.
You can refer to the steps listed below.
Step 1: Get an IP address. Set the network camera and the PC
in the same LAN.
Step 2: Get the physical address from the label of the network
camera.
Step 3: Go to the Run interface and then input the following
commands.
arp –s <IP Address> <MAC>
ping –l 480 –t <IP Address>
Such as：arp -s 192.168.0.125 11-40-8c-18-10-11
ping -l 480 -t 192.168.0.125
Step 4: Reboot the device.
Step 5: You can see the setup is OK if you can see there are
output information such as "Reply from 192.168.0.125 ..." from
the command output lines. Now you can close the command
line.
Step 6: Open the browse and then input http://<IP address>.
Click the Enter button, you can access now.
Figure 5-27
.
Figure 5-27
53