Dahua Network Camera Web 3.0 Operation Manual page 43

Dahua Network Camera Web 3.0 Operation Manual
The image quality will become weak when the device is in the environment with fog or haze, you can
enable defog function to adjust the image definition.
Step 1
Select "Setup > Camera > Conditions > Defog" and the system will display the interface of "Defog"
Figure 5-6
which is shown in
Step 2
It is to set defog mode according to the actual scene.
 When the "Mode" is set as "Manual", it is to manually set intensity and air light mode, the system
will adjust the image definition according to the intensity and air light mode which have been set
previously. As for air light mode, you can set manual or auto.
 When the "Mode" is set as "Auto", the system will auto adjust the image definition according to the
actual scene.
 When the "Mode" is set as "Off", then the defog function is disabled.
Step 3
Click "Save" to complete the config of defog mode.
5.1.1.7 Profile Management
Step 1
Select "Setup > Camera > Conditions > Profile Management" and the system will display the interface of
"Profile Management".
Step 2
Set profile management.
 When the "Profile Management" is set as "Normal", the system will monitor according to the normal
config.
.
Figure 5-6
35