Dahua Network Camera Web 3.0 Operation Manual page 96

Dahua Network Camera Web 3.0 Operation Manual
Step 4
Click "Draw Target" to draw the size model of filtered target in the video image.
Step 5
It is to set the parameters of tripwire, please refer to the following sheet for more details.
Parameter
Object tracking
Working Period
Direction
Object Track
Record
Record Delay
Relay out
Alarm Delay
Send Email
Snapshot
Step 5
Function
Select "Object tracking" to enable the function, refer to "2.4 Video Window
Adjustment" for more details.
Note:
The function is only supported by some models.
Note:
It is to set the alarm period, it can enable alarm event only during the period
range which has been set.
1. Click "Setup" and the system will pop out the interface of "Working
Period".
2. It is to set working period according to the following methods:

You can input time numerical value or press the left mouse button to
drag on the setup interface to set.

There are six periods to be set every day, select the check box in front
of the period, and then the period is valid.

Select week number (it selects Sunday by default, if it selects the whole
week, then it means the setup can be applied to the whole week, you
can also select the check box in front of the week number to implement
independent setting for some days).
3. Click "Save" to complete the setup of working period.
It is to set the direction of tripwire, you can select A->B、B->A、A<->B.
Select "Object Track" and it will enable the function of object track; when the
moving object triggers rule and generates alarm, it will select the display
mode of object track such as 1P+3 or 1P+5 in the preview interface, the
scene of tracking window will follow the moving object till the object leaves
the view range of the camera. Please refer to "2.4.8 Fisheye/Trigger Track"
for more details.
Check it and so when alarm occurs, system will auto record.
System can delay the record for specified time after alarm ended.
Enable alarm activation function. You need to select alarm output port so
that system can activate corresponding alarm device when alarm occurs.
System can delay the alarm output for specified time after alarm ended.
If you enabled this function, System can send out email to alert you when
alarm occurs and ends. User can set email address in Network>SMTP.
Select "Snapshot" and the system will auto trigger alarm and snapshot when
alarm occurs.
88