Dahua Network Camera Web 3.0 Operation Manual page 87

Dahua Network Camera Web 3.0 Operation Manual
Click "Setup" and the system will pop out the interface of "Setting Area", which is shown in
1.
5-56
2. Set area name, it is to set valid area of motion detection according to the actual situation, and it can
set the value of sensitivity and threshold respectively.
The bigger the sensitivity is, the easier it is to generate motion detection, the smaller the threshold is,
the easier it is to generate motion detection; the entire video image is the valid area of motion
detection by default.
Note:

Different colors represent different areas; each area can set different detection area.

The red line in the Oscillogram means triggering motion detection; green line means not triggering
motion detection.
3. Click "Save" to complete area setting.
Step 4
It is to set other parameters of motion detection, please refer to the following sheet for more details.
Figure 5-56
Figure
79