Dahua Network Camera Web 3.0 Operation Manual page 49

Dahua Network Camera Web 3.0 Operation Manual
Parameter
SVC
I Frame
Watermark Settings
Watermark Character

Video Clip
1. Select "Sub Stream 2" in the drop-down box, click "Enable".
2. Enable "Video Clip", click
The system will display the interface of "Area", which is shown in
Function
Frame rate can be encoded by layer. It is a flexible
encoding method. By default, it is 1 as 1 layer. You also
can set 2/3/4 layers.
Here you can set the P frame amount between two I
frames. The value ranges from 1 to 150. Default value
is 50.
Recommended value is frame rate *2.
Select "Watermark Setting" and enable watermark
function. After the watermark function is enabled, you
can check if the video is tampered via verifying
watermark character.
It is the character of watermark verification; it is Digital
CCTV by default.
.
Figure 5-13
.
41