Dahua Network Camera Web 3.0 Operation Manual page 119

Dahua Network Camera Web 3.0 Operation Manual
Parameter Function
Enable Check it and enable the alarm linkage.
Relay-in The default alarm 1，some products can choose alarm 2.
Two types of sensor which are normally open (NO) and normally closed (NC),
switch from normally open to normally closed, open the alarm. Switch from normally
Sensor Type
closed to normally open, shut the alarm.
Check it and set PTZ movement when alarm occurs. Such as go to preset x when
there is an alarm.
PTZ
The event type includes: preset, tour and pattern and so on.
5.3.8.2 Flash Set
Parameter Function
ON/OFF ON means flash is on; OFF means flash is off.
Weak-strong Via dragging this bar to adjust flash brightness.
bar
All Check and it means the day flash works.
Period Period that flash is on.
Figure 5-86
Figure 5-87
111