Dahua Network Camera Web 3.0 Operation Manual
Click "Save" and complete the image parameter config of the camera.
5.1.1.2 Exposure
Step 1
Select "Setup > Camera > Conditions > Exposure". The system will display the "Exposure" interface
Figure 5-2
which is shown in
Step 2
It is to set the exposure parameter, please refer to the following sheet for more details.
Parameter
Anti-flicker
.
Figure 5-2
Note
You can switch to exposure mode when it is in outdoor
mode, it can realize the result in the corresponding exposure
mode.
50Hz: When the current is 50Hz, system can auto adjust the
exposure according to the environment brightness in case
there is any stripe.
60Hz: When the current is 60Hz, system can auto adjust the
exposure according to the environment brightness in case
there is any stripe.
29