SATO CT400 Operator And Technical Reference Manual page 51

Section 4. Programming Reference
Code in this section, there will be a sample data input stream to the printer and the
expected print output. By studying the examples, you can learn how to use the
particular command within a whole block of printer code. Pay particular attention to
the "Special Notes" with each command to learn other important information.
The subject commands are highlighted in bold letters in the Reference Sheets. There
are two parts of most, but not all, commands. The first is the command character
which immediately follows the code. It is always an upper case alpha or a
special character (such as an "&" or a "%"). It is never a lower case alpha character. If
the command requires additional variable information, it is represented by a group of
lower case alpha characters immediately following the command character. For
example, if an is listed following the basic command, the printer will look
for six characters immediately following the command. The first four would represent
the value of and the next two the value of .
The maximum number of characters defined in a parameter is represented by the
number of characters shown in the command structure. For example, a command
followed by an can have up to four characters. In general, commands with only
one parameter following the command can be entered without the leading zeroes.
However, certain commands require the exact number of matching characters. A
command with two parameters listed following the command code without a comma
delimiter, such as require the exact number of digits to be entered. If the
value of is "800" and the value of is "300", then the parameters must be
entered as "08000300". It is recommended that you make it a practice to always
enter leading zeros to prevent any mistakes.
NOTE: These examples assume the use of the Standard Protocol Command Codes,
a parallel interface and a 4 inch wide label in a CT400 printer. The labels for all other
printers will be similar, but, because of different resolutions and print widths may be
larger or scaled differently.
An alphabetical listing of the command codes is contained in Appendix A: Command
Code Quick Reference.
SATO CT Series Printers 9001069A Page 4-7