Page 1
– i t a ) e r ) a i & l i a a ) y l l o r e t ) a i ) a i r t c r t c l l e l i a t s i r t c C C T T 4 4 0 0 0 0 / / C C T T 4 4 1 1 0 0...
Page 2
All rights reserved. No part of this document may be reproduced or issued to third parties in any form whatsoever without the express permission of Bar Code SATO Electronics (S) Pte Ltd. The materials in this document are provided for general information and are subject to change without notice.
Storage -20 – 40 C; 20 – 90% RH, Non Condensing The following is a general list of the CT400 / CT410 series specifications. For a complete listing, please refer to the Operator & Technical Reference, Section 1. Pg 12...
Pg 2 CT4xx Series Quick Guide 6. If you are still unable to get printer output, try the Hex Dump as described in Step 5 under the Parallel Interface troubleshooting. In this case, the printer monitors its RS232C interface for incoming data.
CT4xx Series Quick Guide When you send the print job to the printer and it does not respond, and there is no error message on the PC : Check your data stream for some of the basics. Is your job framed as follows : <ESC>A--DATA--<ESC>Z...
CT4xx Series Quick Guide 9. Apply power to the printer by placing the AC Power switch in the ON (1) position. 10. Print a test label to verify the printer is set up and operating correctly. Ribbon Loading (CT4xxTT only) The SATO CT Series ribbons come shrink-wrapped with a 12”...
Page 7
CT4xx Series Quick Guide ON LINE KEY If the ONLINE LED is illuminated, pressing this switch will place the printer in the OFFLINE mode. If this switch is pressed during printing, the printing process is suspended. To resume printing, press this switch again.
8. Close and latch the Print Head Assembly. 9. Press the LINE key so that the printer is in the OFF LINE mode and then press the FEED key. The label should advance to the next index (label gap or eye-mark) position.
Need help?
Do you have a question about the CT400 and is the answer not in the manual?
Questions and answers