SATO CT400 Operator And Technical Reference Manual page 161

Appendix A: Command Quick Reference
INSTRUCTION DESCRIPTION
IGa Sensor Type. Selects sensor used for label indexing.
a
I2abcde Serial I/F Set. Sets operating parameters for optional serial interface.
a
b
c
d
e
J Journal Print. Provides the ability to print text line by line. Fixed
spacing between lines and characters.
Kab90cc Recall Custom Designed Characters. Recalls for printing a custom
character stored by the Tabcc(data) command.
a
b
bb
Laabb Character Expansion. Expands characters in both directions.
aa
bb
LDa,b,c,d,e,f,g,i Protocol Code Select. Selects the hexadecimal protocol codes to be
used. See Section 4: Programming Reference for details.
M Font type. Specifies the 13W x 20H dot matrix font (including
descenders).
Page A-6
= 0 Reflective (Eye-Mark) Sensor
1 Transmissive (Gap) Sensor
2 No sensor
= Baud rate select
0 9600 BPS
1 19200 BPS
2 38400 BPS
3 57600 BPS
= Data bit select
0 8 data bits
1 7 data bits
= Parity Select
0 No parity
1 Odd parity
2 Even parity
= Stop bit select
0 1 stop bit
1 2 stop bits
= Protocol select
0 Single Item buffer
1 Multi Item buffer
2 X-On/X-Off Flow Control
3 Bi-Com Status Protocol
4 Bi-Com Status Protocol 3. (Used only for software compatibility)
= 1 16 x 16 matrix
2 24 x 24 matrix
= Indicates the format that data stream was stored in
B Binary
H Hexadecimal
= Memory location where the character was stored.
Valid locations are 21 to 52 or "!" to "R" in hex values.
= Multiple to expand horizontally (01-12)
= Multiple to expand vertically (01-12)
9001069A
PAGE
Page 4-89
Page 4-90
Page 4-47
Page 4-19
Page 4-21
Page 4-82
Page 4-34
SATO CT Series Printers