Table of Contents
Advertisement
EonStor F16F-R/S4031-6/4 Installation and Hardware Reference Manual
9270CUPSYCab) is available as an optional accessory. Please refer to
Appendix E for more information about UPS connection.
Ethernet port: All controllers come with a 10/100BaseT Ethernet port
for local/remote management through LAN/WAN. When operating in
the dual-active mode, system configuration is handled through the
Primary (usually controller A) controller. In the event of single
controller failure, the Ethernet port on the surviving controller inherits
the pre-configured IP (if a static IP has been assigned instead of DHCP)
and continues the monitoring or configuration service.
Connect both Ethernet ports (if you are using a dual-controller F16F)
to the Ethernet ports of your network switch.
The Ethernet port on a secondary controller (usually the controller at
the lower position) will stay idle until the occurrence of primary
controller failure.
Shielded cables must be applied to protect against emissions. Connect
the other end of the Ethernet cable to a LAN port of your local Ethernet
hub or switch.
LED indicators: Each rear panel comes with nine (9) LED indicators.
Please refer to Chapter 3 for information on LEDs.
Levers: Two (2) ejection levers on the sides of the controller can be
used to gracefully remove or install the controller.
Restore Default Button/LED: Pressing the "restore default button"
while powering on the subsystem will restore firmware default settings.
The Restore NVRAM Default push button is a function that carries some
risks. Firmware restoration will not destroy the existing logical drive
configurations; however, if the existing logical drives cannot be
adequately associated with host ID/LUNs after firmware default
restoration, data loss or inconsistencies may occur.
1-16
TIPS:
CAUTION!
The "Restore Default" button is a non-latch type push button
accessed through a round opening underneath the Restore Default
LED.
Listed below are the necessary procedures that should be
completed before using this button:
System Components
Advertisement
Table of Contents
