Table of Contents
Advertisement
EonStor F16F-R/S4031 Installation and Hardware Reference Manual
2.5
Installation Overview
2.5.1 Preinstalled Components
Following are pre-installed components that do not need to be installed:
2.5.2 Components to be Installed
You must install the following components:
2.6
Rackmounting
PN: IFT-9273CSlider36
PN: IFT-9273CSlider32
The F16F subsystem is designed to fit into a standard 19" cabinet or rack.
Two (2) rackmount brackets are available from Infortrend for installing the
subsystem into a rack or cabinet. Please contact your system vendor for
further details. The subsystem should be installed in the rack or cabinet
before the hard drives and the drive trays are installed. If the drive trays with
the associated hard drives are installed, the subsystem will be too heavy to
handle. When installing the subsystem into a rack or cabinet it is advisable
that three people assist in the mounting process.
To install the subsystem into a rack or cabinet please refer to the installation
instructions that came with the rackmount brackets.
2-6
1 - LCD keypad panel (mounted on the left-side forearm handle)
2 - Subsystem handles (left and right)
1 - Backplane board
2 (F16F-R4031) or 1 (F16F-S4031) - Controller module(s)
1 - DDR RAM DIMM module (installed in each controller module)
2 (F16F-R4031) or 1 (F16F-S4031) - BBUs
2 - PSUs
2 - Cooling modules
2 - Host connection modules
2 - Expansion modules
Hard drives (separately purchased Fibre drives)
Drive trays
Installation Overview
Advertisement
Table of Contents
