Com1 Serial Port Cable - Infortrend EonStor F16F-R4031-6/4 Installation And Hardware Reference Manual

EonStor F16F-R/S4031 Installation and Hardware Reference Manual
MOD_DEF(
4
2)
MOD_DEF(
5
1)
MOD_DEF(
6
0)
7 Rate Select
LOS
8
V
9
EER
V
10
EER
11 V
EER
12 RD-
13 RD+
14 V
EER
V
15
CCR
V
16
CCT
17 V
EET
18 TD+
19 TD-
20 V
EET
C.2

COM1 Serial Port Cable

COM1 Cable: This cable connects between COM1 serial port on the
controller module to the serial port of a management computer. The serial
port's defaults and requirements are:
1. Set at 38400 baud, 8 bit, 1 stop bit, and no parity.
2. In most cases, connecting RD, TD, and SG is enough to establish
communications with a terminal.
PN: IFT-9270ASCab
C-2
high or open
Module Definition 2: Data line for Serial ID
Module Definition 1: Clock line for Serial ID
Module Definition 0: Grounded within the
module
No connection required
Loss of signal indication; Logic 0 indicates
normal operation
Receiver Ground (common with Transmitter
Ground)
Receiver Ground (common with Transmitter
Ground)
Receiver Ground (common with Transmitter
Ground)
Receiver Inverted DATA out; AC coupled
Receiver Non-inverted DATA out; AC coupled
Receiver Ground (common with Transmitter
Ground)
Receiver Power Supply
Transmitter Power Supply
Transmitter Ground (common with Receiver
Ground)
Transmitter Non-inverted DATA in; 100 ohm
termination between TD+ and TD-; AC coupled
thereafter
Transmitter Inverted DATA in; See TD+
Transmitter Ground (common with Receiver
Ground)
Table C-1: 4G FC Port Pinout Definitions
COM1 Serial Port Cable