Using 2020 With The Serial To Parallel Converter; Table 7 Dip Switch Settings - PerkinElmer Photovac 2020 Manual

SW1
On
SW5
Off
Using 2020 with the Serial to Parallel
Converter
NOTE: 2020 is not classified for use in hazardous locations with
printers or with the serial to parallel converter.
To connect your printer using the serial to parallel converter:
1. Turn 2020 off.
NOTE: You must turn the instrument off before connecting or
disconnecting the printer cable.
2. Unplug the converter from the AC outlet.
3. Use the cable kit (Part No. MX350011) to connect the
2020 I/O connector to the converter.
4. Use the parallel cable, supplied with the converter, to
connect the converter and the printer. If this cable is not
suitable, see Establishing Computer Communications
on page 148 for the cable requirements.
SW2 SW3
Off On
SW6 SW7
Off Off
Table 7 DIP Switch Settings
Connecting Accessories
SW4
On
SW8
Off
99