Table 5 Dip Switch Settings For Baud Rate; Table 6 Dip Switch Settings For Parity - PerkinElmer Photovac 2020 Manual

2020 Software Manual
98
Baud Rate SW1
9600 On
Table 5 DIP Switch Settings for Baud Rate
4. Switch 4 sets the data bits. Off = 7 Bits. On = 8 Bits.
Set the data bits to 8.
5. Use Switches 5 and 6 to set the parity to none.
Parity
None
Table 6 DIP Switch Settings for Parity
6. Switch 7 sets the Handshake mode. Off = Xon/Xoff.
On = DTR. Set the Handshake mode to Xon/Xoff.
7. Use switch 8 to set the data flow direction to serial to
parallel. Off = Serial to Parallel. On = Parallel to Serial.
8. Check your settings. It is imperative that you have the
correct settings or you will be unable to establish
communications. Your settings should match those in
Table 7.
SW2 SW3
Off On
SW5 SW6
Off Off