Computer; Battery Charging; Removing And Replacing The Battery Pack - PerkinElmer Photovac 2020 Manual

Portable photoionization detector

Table of Contents

2020 Software Manual

NOTE: 2020 is not classified for use in hazardous locations with a

printer.

Computer

2020 may also be connected to a computer. The computer must be

100% compatible with an IBM PC. Use the cable kit (Part No.

MX350011) to connect 2020 to the computer.

You will also need terminal emulation software. If you are using

Microsoft® Windows™ you do not need to purchase any separate

software. If you are already using another type of communication or

terminal emulation software package, it is not necessary to purchase

separate software for 2020. See Computer on page 90 for details.

NOTE: 2020 is not classified for use in hazardous locations with a

computer.

Before beginning operation of 2020, the battery pack must be

charged. You can also remove the battery pack and replace it with a

fully charged, spare battery pack (Part No. MX350009).

NOTE: You must use the 220 V battery charger (Part No. MX396013)

in order to comply with the requirements of the applicable

Council Directives.

NOTE: Do not remove or recharge the battery pack in a hazardous

location.

To remove the battery pack

1. If the instrument has been turned on, turn it off by

pressing the ON/OFF key momentarily and then

releasing it.

Table of Contents