Names And Functions Of Parts (Rear Panel); Basic Connections - Sanyo DSR-3716 Instruction Manual

Names and functions of parts (rear panel)

Basic connections

1 Clear button (ALL RESET)
Press to reset the clocks connected to the digital video
recorder to their initial values.
2 Video output terminal (VIDEO OUT)
To output the camera input.
1
IN
OUT
ALL
RESET
5 Microphone input terminal
(MIC IN)
External microphone can be
connected to this terminal.
Microphone
(sold separately)
4 Audio input/output terminals (AUDIO IN/OUT)
These terminals are used in connection with an amplifier to
input external audio from a microphone, or to listen to the
audio using external speakers.
Amplifier
(sold separately)
The audio input terminal and the microphone
input terminal cannot be used for
simultaneous audio input. If both are
connected, the microphone input terminal
will be enabled.
ALL
RESET
2 3 4 5 6 7 8 9
AUDIO MONITOR OUT
MAIN MON2
IN OUT MIC IN USB
7 USB terminal (USB)
This terminal connects to an
optional CD-R/RW drive.
MIC IN
Audio output
Audio
input
AUDIO
IN OUT
3 Video input terminal (VIDEO IN)
Connect SANYO protocol cameras (dome or zoom) or generic
cameras to these terminals.
Dome camera (sold separately)
1 2
ALARM IN
C 1 2 3
10 11 12 13 14 15 16
C 1 2 3
A RS-485 B REMOTE
LAN RS-485 SENSOR
C
TERMINATE ALARM OUT
OFF ON
DO NOT CONNECT TO PHONE LINE
8 Power socket and cord tie
Securely connect the power cable supplied as
an accessory to the power socket, and use the
cord tie to attach it to the
USB
cable holder.
6 Monitor connection terminal (MONITOR OUT)
Main monitor (MAIN):
Connect to this terminal for normal surveillance.
Monitor 2 (MON2):
Connect to this terminal for convergence surveillance.
Display is possible only in full-screen mode.
Video input terminal
01
03
MENU
Monitor (sold separately)
If monitor 2 is not synchronized with the connected
cameras, vertical image instability may occur when
switching the camera video.
3 4 5
AC IN
4 5 6 7 8 9 10 11 12 13 14 15 16
4 5 6 7 8 9 10 11 12 13 14 15 16
R1 R2 C
CONTROL
(AC IN~)
MONITOR OUT
MAIN MON2
Video input terminal
02
04
AUTO MODE POWER MENU AUTO MODE POWER
Monitor (sold separately)
Foreword 10