Conductivity / Specific Resistance - wtw inoLab Cond Level 1 Operating Manual

Conductivity
Specific resistance

4.2.1 Conductivity / Specific resistance

Note
You can display measured values in the units µS/cm (con-
ductivity) or MΩ·cm (specific resistance). This setting is de-
scribed in Abschnitt 4.5 C
Thus, you can carry out conductivity measurements or mea-
surements of the specific resistance:
1 Perform the preparatory activities according to sec-
tion 4.2.
2 Immerse the conductivity measuring cell into the test
sample.
m
3 Press the
play. Depending on the setting, one of the following
display indicators appears on the display:
4 If necessary, set the temperature by pressing
(see section 4.2 on page 17).
5 Wait for a stable measured value.
ONFIGURATION
key until appears in the status dis-
Operation
.
u d
19