Danfoss VLT 8000 AQUA series Operating Instructions Manual page 136

415 Units relating to closed loop
(REF. / FDBK. UNIT)
No unit [0] °C
% [1] GPM
rpm [2] gal/s
ppm [3] gal/min
pulse/s [4] gal/h
l/s [5] lb/s
l/min [6] lb/min
l/h [7] lb/h
kg/s [8] CFM
kg/min [9] ft
kg/h [10] ft
3
m /s [11] ft
3
m /min [12] ft/s
3
m /h [13] in wg
m/s [14] ft wg
mbar [15] PSI
bar [16] lb/in
Pa [17] HP
KPa [18] °F
mWG [19]
kW [20]
Function:
Selection of unit to be shown on the display.
This unit will be used if Reference [unit] [2] or
Feedback [unit] [3] has been selected in one of the
parameters 007-010, as well as in the Display mode.
In Closed loop, the unit is also used as a unit for
Minimum/Maximum reference and Minimum/ Maximum
feedback, as well as Setpoint 1 and Setpoint 2.
Description of choice:
Select the required unit for the reference/feed-
back signal.
= factory setting. () = display text [] = value for use in communication via serial communication port
136
[21]
[22]
[23]
[24]
[25]
[26]
[27]
[28]
[29]
3
/s [30]
3
/min [31]
3
/h [32]
[33]
[34]
[35]
[36]
2
[37]
[38]
[39]
®
VLT 8000 AQUA
MG.83.A2.02 - VLT is a registered Danfoss trademark