Show Running-Config - Cisco Aironet Wave 2 Cli Command Reference Manual

show running-config

show running-config

To display the contents of the currently running configuration on the access point, use the show running-config
command.
show running-config
Privileged EXEC (#)
Command Modes
Command History
Release
8.1.111.0
The following example shows how to view the contents of the currently running configuration on
the access point:
cisco-wave2-ap# show running-config
AP Name
Admin State
AP Mode
AP Submode
Location
Reboot Reason
Primary controller name
Primary controller IP
Secondary controller name
Secondary controller IP
Tertiary controller name
Tertiary controller IP
Controller from DHCP offer : <controller-dhcp-server-address>
Controller from DNS server : <controller-dns-server-address>
AP join priority
IP Prefer-mode
CAPWAP UDP-Lite
Last Joined Controller name: wlc3504
DTLS Encryption State
Discovery Timer
Heartbeat Timer
CDP State
Watchdog monitoring
IOX
RRM State
LSC State
SSH State
AP Username
Session Timeout
Extlog Host
Extlog Flags
Extlog Status Interval
Syslog Host
Syslog Facility
Syslog Level
Core Dump TFTP IP Addr
Core Dump File Compression : Disabled
Core Dump Filename
Client Trace Status
Cisco Aironet Wave 2 Access Point Command Reference, Release 8.7
130
Modification
This command was
introduced.
: ap1540
: Enabled
: Local
: None
: default location
: Config Mwar
: cisco_3504
: <controller-ip-address>
:
:
:
:
: 1
: IPv4
: Unconfigured
: Disabled
: 10
: 30
: Enabled
: Enabled
: Disabled
: Enabled
: Disabled
: Enabled
: admin
: 0
: 0.0.0.0
: 0
: 0
: <syslog-host-ip-address>
: 0
: errors
:
:
: Enabled(All)
show Commands