debug traffic
debug traffic
To enable traffic debugging, use the debug traffic command.
debug traffic {host {icmpv6 | ip | ipv6 | tcp | udp { verbose}} | wired {ip | tcp | udp
{verbose}}}
Syntax Description
host
wired
verbose
icmpv6
ip
ipv6
tcp
udp
Privileged EXEC (#)
Command Modes
Command History
Release
8.1.111.0
Examples
The following example shows how to enable debugging of host IP traffic dump:
cisco-wave2-ap# debug traffic host ip
Cisco Aironet Wave 2 Access Point Command Reference, Release 8.7
74
Enabling host traffic debugging
Enabling wired traffic debugging
Display verbose output
Enabling host ICMPv6 traffic dump
Enabling host IP traffic dump
Enabling host IPv6 traffic dump
Enabling TCP traffic dump
Enabling UDP traffic dump
Modification
This command was
introduced.
debug Commands