Show Rrm Rogue Detection - Cisco Aironet Wave 2 Cli Command Reference Manual

show rrm rogue detection

show rrm rogue detection

To view RRM rogue detection configuration parameters, use the show rrm rogue detection command.
show rrm rogue detection {adhoc |ap |clients |config |rx-stats} Dot11Radio radio-interface-number
Syntax Description
adhoc
ap
clients
config
rx-stats
Dot11Radio
radio-interface-number
Privileged EXEC (#)
Command Modes
Command History
Release
8.1.111.0
The following example shows how to view the RRM rogue detection configuration details:
cisco-wave2-ap# show rrm rogue detection config
Rogue Detection Configuration for Slot 0:
Rogue Detection Mode : Enabled
Rogue Detection Report Interval : 10
Rogue Detection Minimum Rssi : -90
Rogue Detection Transient Interval : 0
Rogue Detection Flex Contain : Disabled
Rogue Detection Flex Contain Adhoc : Disabled
Rogue Detection Flex Contain SSID : Disabled
Rogue Containment Autorate : Disabled
Scan Duration : 180000
Channel Count : 11
Transient Threshold : 0
Rogue Detection Configuration for Slot 1:
Rogue Detection Mode : Enabled
Rogue Detection Report Interval : 10
Rogue Detection Minimum Rssi : -90
Rogue Detection Transient Interval : 0
Rogue Detection Flex Contain : Disabled
Rogue Detection Flex Contain Adhoc : Disabled
Rogue Detection Flex Contain SSID : Disabled
Rogue Containment Autorate : Disabled
Cisco Aironet Wave 2 Access Point Command Reference, Release 8.7
128
Displays the master adhoc rogue AP list for a 802.11 radio slot; valid values are 0
and 1
Displays rogue detection parameters for the AP for a 802.11 radio slot; valid values
are 0 and 1
Displays master list of rogue clients
Displays rogue detection configuration on the AP
Displays rogue detection receive statistics on the 802.11 interfaces of an AP
Specifies 802.11 radio intereface
The 802.11 radio interface number; valid values are 0 and 1
Modification
This command was
introduced.
show Commands