Step 8: Network Settings; Introduction - Roland VersaUV LEF-200 First Step Manual

4.
Make sure the drain bottle is installed, and
then press [ENTER].
The machine is now filled with ink.
5.
Close the front cover.
Prepare for Using This Printer

STEP 8: Network Settings

Introduction

Make sure the machine is connected to the
network by an Ethernet cable.
The network settings on the machine must
be made manually, using the operation panel.
For information about how to make the
settings, refer to "Make the Network Settings
on the Printer" (P. 33) later in this step.
Also, to perform printing from this machine,
the RIP & PRINT MANAGEMENT SOFTWARE
included with the machine must be
installed on the computer you are using.
For information about installation, refer
to the documentation for the RIP & PRINT
MANAGEMENT SOFTWARE.
This machine has a built-in print server as a
network interface. When you use the print
server, you can send print data to the machine
from anywhere on the network. TCP/IP is used
as the protocol.
NOTE
The examples used in the procedures for
making the settings described in this section
assume you are using one computer and
one machine. The procedures and setting
values described here may not be suitable
for all operating environments.
If the computer you are using is connected
to a number of networked devices or to the
Internet, incorrect settings may adversely
affect the entire network. For detailed
information about the settings, consult your
network administrator.
31