Roland VersaUV LEF-200 First Step Manual page 36

Prepare for Using This Printer
8.
When you have finished making the setting,
press [ENTER].
9.
Press [ ].
The screen shown below appears again.
NETWORK
IP ADDRESS
34
2. Set the subnet mask.
1.
On the screen of step 9 of "1. Set the IP
address." (P. 33), press [ ].
The screen shown below appears.
NETWORK
SUBNET MASK
2.
Press [ ] twice.
The screen shown below appears.
SUBNET MASK
000.000.000.000
3.
Press [ ] or [ ] to select the address number.
4.
Press [ ].
5.
Repeat steps 3 and 4 to set the subnet mask
(255.255.255.0).
For the subnet mask, make the setting the
same value as the one used by the computer.
Here, "255.255.255.000" is entered by way of
example.
SUBNET MASK
255.255.255.000
6.
When you have finished making the setting,
press [ENTER].
7.
Press [ ].
The screen shown below appears again.
NETWORK
SUBNET MASK
If you connect the computer and the machine
on a one-to-one basis, this completes the
settings to make on the printer. Proceed to
"Make the Port Settings for the RIP & PRINT
MANAGEMENT SOFTWARE" (P. 35).
If you need to set the gateway address,
proceed to the following procedure, "3. Set
the gateway address. " (P. 35).