Roland VersaUV LEF-200 First Step Manual page 2

For the USA
FEDERAL COMMUNICATIONS COMMISSION RADIO
FREQUENCY INTERFERENCE STATEMENT
NOTE: This equipment has been tested and found to comply
with the limits for a Class A digital device, pursuant to Part 15 of
the FCC Rules.
These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in
a commercial environment.
This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications.
Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be
required to correct the interference at his own expense.
Unauthorized changes or modification to this system can void
the users authority to operate this equipment.
Use only I/O cables that have been designed and manufactured
specifically for this device.
For Canada
CAN ICES-3 (A)/NMB-3(A)
For California
WARNING
This product contains chemicals known to cause cancer, birth
defects and other reproductive harm.
For EU Countries
WARNING
This is a Class A product. In a domestic environment this
product may cause radio interference in which case the user
may be required to take adequate measures.
For EU Countries
Manufacturer:
ROLAND DG CORPORATION
1-6-4 Shinmiyakoda, Kita-ku, Hamamatsu-shi, Shizuoka-ken,
431-2103 JAPAN
The importer in the EU:
Roland DG EMEA, S.L.
Parc Tecnologic del Valles C/ Ceramistes, 6 08290 Cerdanyola del
Valles / Barcelona Spain
This system (including the housing and safety device) is a Class 1 laser product
Complies with IEC 60825-1 Edition 2.0 (2007-03).
Complies with FDA performance standards for laser products except for deviations pursuant to Laser notice No.50 dated June 24, 2007.
Caution - Use of controls or adjustments or performance of procedures other than those specified herein may result in radiation exposure.
NOTICE
Grounding Instructions
• In the event of a malfunction or breakdown, grounding
provides a path of least resistance for electric current to
reduce the risk of electric shock. This tool is equipped with an
electric cord having an equipment-grounding conductor and
a grounding plug. The plug must be plugged into a matching
outlet that is properly installed and grounded in accordance
with all local codes and ordinances.
• Do not modify the plug provided - if it will not fit the outlet,
have the proper outlet installed by a qualified electrician.
• Improper connection of the equipment-grounding conductor
can result in a risk of electric shock. The conductor with
insulation having an outer surface that is green with or without
yellow stripes is the equipment-grounding conductor. If repair
or replacement of the electric cord or plug is necessary, do
not connect the equipment-grounding conductor to a live
terminal.
• Check with a qualified electrician or service personnel if the
grounding instructions are not completely understood, or if in
doubt as to whether the tool is properly grounded.
• Use only 3-wire extension cords that have 3-prong grounding
plugs and 3-pole receptacles that accept the tool's plug.
• Repair or replace damaged or worn out cord immediately.
Operating Instructions
• KEEP WORK AREA CLEAN. Cluttered areas and benches invites
accidents.
• DON'T USE IN DANGEROUS ENVIRONMENT. Don't use power
tools in damp or wet locations, or expose them to rain. Keep
work area well lighted.
• DISCONNECT TOOLS before servicing; when changing
accessories, such as blades, bits, cutters, and like.
• REDUCE THE RISK OF UNINTENTIONAL STARTING. Make sure
the switch is in off position before plugging in.
• USE RECOMMENDED ACCESSORIES. Consult the owner's
manual for recommended accessories. The use of improper
accessories may cause risk of injury to persons.
• NEVER LEAVE TOOL RUNNING UNATTENDED. TURN POWER OFF.
Don't leave tool until it comes to a complete stop.