Communication Of I/O Data; Lump Mode - Mitsubishi Electric QJ71PB93D User Manual

7 PROGRAMMING

7.3 Communication of I/O Data

7.3.1 LUMP mode

7- 5
(1) System configuration example
A program example for I/O data communication is provided here to show the
case where the LUMP mode is used for data assignment of the following
configuration.
Refer to (2) for the outline of the program example.
No. 1 Module
0 QJ71PB93D
1 QX41
2 QY41P
3 Q64AD
4 Q64DA
1: Modules are to be mounted to the base unit from slot 0 as shown in the figure. Start I/O No.
data are to be set as follows:
REMARKS
Refer to Section 5.2.2 for details on the LUMP mode.
No.0 No.1 No.2 No.3 No.4
Input signal
X0 to X1F
X20 to X3F

X60 to X6F
X70 to X7F
MELSEC-Q
Output signal
Y0 to Y1F

Y40 to Y5F
Y60 to Y6F
Y70 to Y7F
7 - 5