Table of Contents
Advertisement
5 SETTINGS AND PROCEDURES BEFORE SYSTEM OPERATION
5 - 21
(3) Completion of the self-diagnostics
Perform the following operation after checking normal or abnormal termination of
the self-diagnostics.
(a) When completed normally
Return the operation mode of the QJ71PB93D to the normal operation
mode.
Doing this will place the QJ71PB93D in the state of waiting for parameter
reception from the master station.
1) Select [Online]
menu of GX Works2.
2) Set 0
(normal operation mode) in the operation mode change request
H
area (buffer memory address: 8CF
3) Turn on the operation mode change request signal (Y11).
(b) When completed abnormally
If the self-diagnostic result is an error, please consult your local Mitsubishi
representative.
(4) Cautions
During the self-diagnosis, do not monitor the QJ71PB93D buffer memory from
GX Works2.
Monitor may stop if the buffer memory is monitored during the self-diagnosis.
[Monitor]
[Device/Buffer Memory Batch] from the
).
H
MELSEC-Q
5 - 21
Advertisement
Table of Contents
