Omron Hornet 565 Quick Setup Manual page 12

Parts Table
Part Cable and Parts List
A eAIB XSYSTEM Cable Assembly
B User E-Stop, Safety Gate
C XUSR Jumper Plug
D Front Panel
E Front Panel Cable
F Front Panel Jumper Plug
G XMCP Jumper Plug
H T20 Bypass Plug
J T20 Adapter Cable
K T20 Pendant (option)
L AC Power Cable (option)
M 24 VDC Power Cable (option)
N 24 VDC, 6 A Power Supply
(option)
P Ethernet Cable - PC -> PLC
(Only while programming PLC)
Q Ethernet Cable - switch -> eAIB
R Ethernet Cable - switch ->
SmartVision MX
S Ethernet switch, cable for
SmartVision MX.
T Camera and cable
U eAIB XBELTIO cable
V Y-adapter cable
The XUSR, XMCP, and XFP jumpers intentionally bypass safety connections so you can test
the system functionality during setup.
Hornet 565 Robot Quick Setup Guide, 14692-000 Rev C
Chapter 1: Hornet 565 Quick Setup Guide
Part #
13323-000
n/a
04736-000
90356-10358
10356-10500
10053-000
04737-000
10048-000
10051-003
10055-000
04118-000
04120-000
04536-000
n/a
n/a
n/a
n/a
n/a
13463-000
09443-000
WARNING: Under no circumstances should you run the
system, in production mode, with all three jumpers
installed. This would leave the system with no E-Stops.
Page 12 of 18
Part of: Notes
standard, eAIB
n/a user-supplied
13323-000 standard, eAIB
or user-supplied
90356-10358 or user-supplied
13323-000 standard, eAIB
13323-000 standard, eAIB
10055-000 standard, T20
10055-000 standard, T20
option
90565-010 or user-supplied
90565-010 or user-supplied
90565-010 or user-supplied
n/a user-supplied
n/a user-supplied
n/a user-supplied
n/a option,
user-supplied
n/a option
option
option