Drive Drawer - HPE D2220sb Maintenance And Service Manual

Install the storage blade.
10.
Power up the partner server blade.
11.
After you replace the system board, you must re-enter the product identification and serial number in the
Onboard Administrator using the command line. The Onboard Administrator CLI can be accessed locally
from a laptop connected to a serial port connector on the rear of the Onboard Administrator module or
remotely through a Telnet or SSH session.
To enter the product information:
Obtain the serial number from the product information tag.
1.
Access the Onboard Administrator CLI.
2.
Issue the following command in the CLI:
3.
SET DEVICE SERIAL_NUMBER BLADE <bay number> <serial number>

Drive drawer

WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
CAUTION: To prevent damage to electrical components, properly ground the D2220sb
before beginning any installation procedure. Improper grounding can cause ESD.
CAUTION: Do not operate the D2220sb with the access panel open or removed. Operating
the D2220sb in this manner results in improper airflow and improper cooling that can lead to
thermal damage.
CAUTION: If the pass-through board and cable are not removed before removing the drive
drawer, then damage could occur to the drive drawer, cable, and controller board.
To remove the component:
Back up all data on the D2220sb.
1.
Power down the partner server blade (on page 20).
2.
Remove the D2220sb (on page 20).
3.
Remove all drives ("Remove the drives" on page 22).
4.
Remove the access panel (on page 25).
5.
Removal and replacement procedures 36