Evaluation Board Setup Procedures - Analog Devices EVAL-AD7403FMCZ User Manual

UG-683

EVALUATION BOARD SETUP PROCEDURES

The EVAL-AD7403FMCZ connects to the
system demonstration platform. The
the controller board, which is the communication link between
the PC and the main evaluation board. Figure 2 shows a
photograph of the connections between the
daughter board and the EVAL-SDP-CH1Z
After following the instructions in the Software Installation
Procedures section, set up the evaluation and SDP-H1 boards as
detailed in this section.
Warning
The evaluation software and drivers must be installed before con-
necting the evaluation board and
the USB port of the PC to ensure that the evaluation system is
correctly recognized when it is connected to the PC.
Connecting the Evaluation and SDP Boards to a PC
1. Ensure that all configuration links are in the appropriate
positions (see Table 2).
2. Connect the EVAL-AD7403FMCZ
FMC connector on the EVAL-SDP-CH1Z
3. The EVAL-SDP-CH1Z
supply adapter, which is included in the
Connect this power supply to the dc barrel connector labeled
+12V_VIN on the EVAL-SDP-CH1Z
4. Connect the EVAL-SDP-CH1Z
USB cable enclosed in the
EVAL-SDP-CH1Z
EVAL-SDP-CH1Z board is
EVAL-AD7403FMCZ
board.
EVAL-SDP-CH1Z board to
board securely to the J4
board.
board requires an external power
EVAL-SDP-CH1Z
board.
board to the PC via the
EVAL-SDP-CH1Z kit.
EVAL-AD7403FMCZ User Guide
Verifying the Board Connection
1. Allow the Found New Hardware Wizard to run after the
EVAL-SDP-CH1Z
are using Windows XP, you may need to search for the
EVAL-SDP-CH1Z
for the drivers for the
by the operating system.)
2. Check that the board is connected to the PC correctly
using the Device Manager of the PC.
a. Access the Device Manager as follows:
i. Right-click My Computer and then click Manage.
ii. A dialog box appears asking for permission to
allow the program to make changes to your
computer. Click Yes.
iii. The Computer Management box appears. From
the list of System Tools, click Device Manager.
b. Under ADI Development Tools, Analog Devices
SDP-H1 should appear (see Figure 12), indicating that
the EVAL-SDP-CH1Z
that the board is connected to the PC correctly.
kit.
Checking that the Board Is Connected to the PC Correctly
Disconnecting the
Caution
Always remove power from the
reset tact switch (located alongside the mini-USB port) before
removing the EVAL-AD7403FMCZ
Rev. 0 | Page 6 of 20
board is plugged into your PC. (If you
drivers. Choose to automatically search
EVAL-SDP-CH1Z board if prompted
driver software is installed and
Figure 12. Device Manager:
EVAL-AD7403FMCZ Board
EVAL-SDP-CH1Z
daughter board.
or click the