Machine Speed; Machine Speed & Operating Direction; Motor & Belt; Lubrication - KANSAI SPECIAL JJ Series Parts List, Instructions

【 2】 MACHINE SPEED
2-1 Machine speed & operating direction
Refer to maximum and average speed of the
machine at the table below. If your machine is
new, you have to operate the machine at 15~20%
lesser than maximum speed for the first 200 hours
(about one month) so that you can break it in.
The machine pulley (hand-wheel)
clockwise as seen from the hand-wheel end of the
machine.
2-2 Motor & belt
Motor: 3 phase, 2 pole 400W clutch motor
Belt: M type V belt
Select the proper motor pulley according to the machine speed (refer to the motor pulley
outer diameter on the table below).
Adjust the position of the motor by pressing the middle of the belt with the index finger
until the belt can bent 1~2cm inward. (See the illustration above)
＜ Machine speed ＞
Model Maximum speed
JJ5004GS
7500rpm
JJ5005GS
JJ5014GH
7500rpm
JJ5014GS
JJ5004GE
7000rpm
JJ5014GE
＜ Motor pulley ＞
Machine speed (RPM)
Motor pulley Outer
diameter (mm) 50Hz
80 4200
90 4700
100 5200
110 5800
120 6300
rotates
Average speed
6500rpm
6500rpm
6000rpm
60Hz
5000
5700
6300
6900
7500
J J
J J s e r i e
s e r i e
3
【 3】 LUBRICATION

3-1 Oil specification

Kansai Special's genuine oil is highly recommended.
(Parts number 54-045 : 700cc)

3-2 Oiling

■Lubrication

Take the Oil Pot A and fill the machine with the
genuine oil until the indicator reaches the line H in
the oil gauge B.
Most of the time, fill up the oil until the indicator
appears between the line H and L.
■ Lubrication check
When the lubrication is over, run the machine to
check for oil splashing in the window A.
3-3 Oil & Filter replacement
To prolong machines' lifespan, replace the oil in 250
hour use. Follow the procedure below.
1. Take the V belt off the motor pulley and then
take the machine off the table.
2. Loosen the screw C and drain all the oil from the
machine.
3. After the oil has been drained, tighten the screw
C without fail.
4. Fill up the oil as instructed above.
If filter E is dirty, the machine is not lubricated
properly. Normally, it has to replace every 6 month.
Check for proper function of the lubrication system
and maintain the proper amount and type of oil
periodically.
In order to replace the filter E, loosen all the
necessary parts (a,b).
In case the filter is clogged, replace it with a new
one.
s
s
J J
J J s e r i e
s e r i e
4
s
s