Machine Speed; Machine Speed & Direction In Which The Machine; Pulley Runs; Motor & Belt - KANSAI SPECIAL DVK1702B Instruction

【2】MACHINE SPEED
2-1 Machine speed & direction in which the machine pulley runs
Refer to the table below for maximum and standard
speeds of the Series. To extend machine life, run
the machine approximately 15-20% below the
maximum speed for the first 200 hours of operation
(approx. 1 month). Then run the machine at the
standard speed.
counterclockwise as seen from the end of the
machine pulley.
2-2 Motor & belt
Motor : 3-phase，2-pole，400W clutch motor
Belt : M type V belt
Select the proper motor pulley according to the
machine speed (refer to the motor pulley outer
diameter on the table below).
position the motor by pressing the finger onto the
middle of the belt so that 1~2cm deflection can be
obtained (see the illustration on the right).
< Machine speed >
Type
P，PMD，B
BK，EHD，MLH
< Motor pulley selection table >
Motor pulley
outer diameter
(mm)
70
80
90
100
110
The machine pulley turns
Adjust where to
Maximum speed
4500SPM
4000SPM
Machine speed (SPM)
50Hz 60Hz
2900 3450
3300 3900
3700 4400
4100 (4900)
4500
Standard speed
4000SPM
3500SPM
2