Wireless Lan Security - Cisco 8832 Administration Manual

Cisco IP Conference Phone Administration
Cisco IP Phone AP Configuration
Configuration
EAP-TLS EAP-TLS
PEAP-MSCHAPV2 PEAP-MSCHAPV2
For more information about configuring authentication and encryption schemes on APs, see the Cisco Aironet
Configuration Guide for your model and release under the following URL:
http://www.cisco.com/cisco/web/psa/configure.html?mode=prod&level0=278875243

Wireless LAN Security

Cisco phones that support Wi-Fi have more security requirements and require extra configuration. These extra
steps include installing certificates and setting up security on the phones and on the Cisco Unified
Communications Manager.
For additional information, see Security Guide for Cisco Unified Communications Manager.
Cisco IP Phone Administration Page
Cisco phones that support Wi-Fi have special web pages that are different from the pages for other phones.
You use these special web pages for phone security configuration when Simple Certificate Enrollment Protocol
(SCEP) is not available. Use these pages to manually install security certificates on a phone, to download a
security certificate, or to manually configure the phone date and time.
These web pages also show the same information that you see on other phone web pages, including device
information, network setup, logs, and statistical information.
Configure the Administration Page for Phone
The administration web page is enabled when the phone ships from the factory and the password is set to
Cisco. But if a phone registers with Cisco Unified Communications Manager, the administration web page
must be enabled and a new password configured.
Enable this web page and set the sign-in credentials before you use the web page for the first time after the
phone has registered.
Once enabled, the administration web page is accessible at HTTPS port 8443 (https://x.x.x.x:8443,
where x.x.x.x is a phone IP address).
Before you begin
Decide on a password before you enable the administration web page. The password can be any combination
of letters or numbers, but it must be between 8 and 127 characters in length.
Your username is permanently set to admin.
802.1x
WPA
WPA2
802.1x
WPA
WPA2
Cisco IP Conference Phone 8832 Administration Guide for Cisco Unified Communications Manager
WEP CCKM
TKIP CCKM
AES FT, CCKM
WEP CCKM
TKIP CCKM
AES FT, CCKM
Wireless LAN Security
79