Cisco 8832 Administration Manual page 117

Cisco IP Conference Phone Administration
Table 15: EnergyWise Configuration Fields
Field
Enable Power Save Plus
Phone On Time
Phone Off Time
Description
Selects the schedule of days for which the phone powers off. Select multiple days by pressing
and holding the Control key while clicking on the days for the schedule.
By default, no days are selected.
When Enable Power Save Plus is checked, you receive a message that warns about emergency
(e911) concerns.
Caution While Power Save Plus Mode (the "Mode") is in effect, endpoints that are configured
for the mode are disabled for emergency calling and from receiving inbound calls. By
selecting this mode, you agree to the following: (i) You take full responsibility for
providing alternate methods for emergency calling and receiving calls while the mode
is in effect; (ii) Cisco has no liability in connection with your selection of the mode
and all liability in connection with enabling the mode is your responsibility; and (iii)
You fully inform users of the effects of the mode on calls, calling and otherwise.
Note To disable Power Save Plus, you must uncheck the Allow EnergyWise Overrides check
box. If the Allow EnergyWise Overrides remains checked but no days are selected in
the Enable Power Save Plus field, Power Save Plus is not disabled.
Determines when the phone automatically turns on for the days that are in the Enable Power Save
Plus field.
Enter the time in this field in 24-hour format, where 00:00 is midnight.
For example, to automatically power up the phone at 07:00 a.m. (0700), enter 07:00. To power
up the phone at 02:00 p.m. (1400), enter 14:00.
The default value is blank, which means 00:00.
The Phone On Time must be at least 20 minutes later than the Phone Off Time. For
Note
example, if the Phone Off Time is 07:00, the Phone On Time must be no earlier than
07:20.
The time of day that the phone powers down for the days that are selected in the Enable Power
Save Plus field. If the Phone On Time and the Phone Off Time fields contain the same value, the
phone does not power down.
Enter the time in this field in 24-hour format, where 00:00 is midnight.
For example, to automatically power down the phone at 7:00 a.m. (0700), enter 7:00. To power
down the phone at 2:00 p.m. (1400), enter 14:00.
The default value is blank, which means 00:00.
The Phone On Time must be at least 20 minutes later than the Phone Off Time. For
Note
example, if the Phone Off Time is 7:00, the Phone On Time must be no earlier than
7:20.
Cisco IP Conference Phone 8832 Administration Guide for Cisco Unified Communications Manager
Schedule EnergyWise on Cisco IP Phone
107