Confidential
Pre-assembly D: Presenter table assembly
Reassembly
Part name
step
1
Table, presenter
P. washer (4 × × × × 0.8 × × × × 10) × 1
C.B.P-tite (M3 × × × × 8)
★
2
Paper detector, assembly 1
★
3
Paper detector assembly×1
★
circuit board assembly
table, presenter
6-40 Assembly and Disassembly
× 1
Attach the circuit board to the table, presenter and secure it with a C.B.P-
tite (M3 × × × × 8) screw via a P. washer.
× 1
< Check >
Tightening torque: 735 to 931 mN•m {7.5 to 9.5 kg•cm}
Slide the paper detector, assembly 1 (with a large lever) into the snap
× 1
fastener on the the circuit board side.
< Check >
Make sure that the paper detector, assembly 1 is fit securely into the snap
fasteners.
Slide the paper detector assembly (with a small lever) to the other snap
fastener.
< Check >
Make sure that the paper detector assembly is fit securely into the snap
fasteners.
Make sure the correct mounting position for the paper detector,
assembly 1 and the paper detector assembly to attach.
C.B.P-tite (M3 × 8)
snap fasteners
Assembly procedure
paper detector, assembly 1
P. washer (4 × 0.8 × 10)
paper detector
assembly
Rev. A