Epson EU-T432 Technical Manual page 115

Confidential
Reassembly
Part name
step
C.B (3 × × × × 4)
4
Control circuit board
module
★
5 LED switch circuit board
assembly
C.B (M3 × × × × 4)
★
6 H. nut (2.6)
★
Rev. A
× 4
Connect the cable head cable head and the cable, printer cable head cable head
the connectors on the control circuit board module
× 1
Pass the lead wire, NE detector between the cover, circuit board lower
and the control circuit board module; then secure the control circuit
board module to the cover, circuit board lower with C.B (3 × × × × 4) screws.
< Check >
Tightening torque: 735 to 931 mN•m {7.5 to 9.5 kg•cm}
When securing the control circuit board module, slightly push it downward.
Pass the hooks of the parallel interface through the hole on the circuit
board, lower.
Secure the LED switch circuit board assembly with C.B (M3 × × × × 4) screws.
× 1
× 2
< Check >
Tightening torque: 735 to 931 mN•m {7.5 to 9.5 kg•cm}
× 2
Secure the serial connector to the cover, circuit board lower with H. nuts.
< Check >
Tightening torque: 392 to 588 mN•m {4.0 to 6.0 kg•cm}
H. nut
EU-T432 Technical Manual
Assembly procedure
cable, printer of the printer module to cable, printer cable, printer
LED switch circuit board assembly
C.B (3 × 4)
hook
Assembly and Disassembly 6-55
C.B (3 × 4)