Pump Assembly And Cap Assembly Removal - Epson Stylus Color 600 Service Manual

Color ink-jet printer
Hide thumbs Also See for Stylus Color 600:
Table of Contents

Advertisement

EPSON Stylus Color 600 Service Manual

3.2.5.2 Pump Assembly and Cap Assembly Removal

1. Removing the upper housing. (Refer to Section 3.2.1)
2. Removing the control panel assembly. (Refer to section 3.2.3)
3. Removing "Waste Ink Pad Assembly". (Refer to section 3.2.4)
4. Loosen 2 screws (No.1) fixing the exit frame assembly and disengage the frame from the side
frames. Then, put the printer mechanism on its back as you see the bottom of the mechanism.
5. At the right-hand of the mechanism, unhook the cap assembly by releasing one hook and take out
the cap assembly by lifting up the right end of it. (Note that the cap assembly is still connected to
the pump assembly by the ink tube.)
6. Remove 2 screws (No.5) fixing the pump assembly to the frame.
7. Unhook the pump assembly by releasing one hook and slide the pump assembly to the right
direction to remove it.

Be careful not to damage rubber part of the cap assembly. (Damaging the rubber part causes
incomplete capping and the nozzle condition become unstable.)

Be careful with the followings when you handle "CLEANER, HEAD":

Do not handle it with bare hands and avoid attaching any oil or dust.

Make sure that the rubber side of "CLEANER, HEAD" is facing to the right.

Be careful not to popping the components from the pump assembly when you remove it from the
mechanism, as there is a spring inside the pump assembly.

Be sure that the ink tube from the cap assembly is routed to the correct position and not pinched
by the cap assembly ad the frame.

Verify that "CLEANER, HEAD" moves smoothly by rotating "GEAR, 67.2" after you re-assemble
the pump assembly. (Hold the cap assembly to the right while you rotating the gear for check)
OK
3-12
CAUTION
WORK POINT
Figure 3-9. Ink Tube Routing
NG
Rev. A

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents