Loading And Removing Paper Roll; Loading A Paper Roll - Epson EU-T432 Technical Manual

Confidential
Loading and Removing a Paper roll

Loading a Paper roll

Follow the steps below to load or remove the paper roll. See Figure 3-3 on page 3-7.
Note:
Use only the paper specified in the EU-T432 specifications issued by Seiko Epson Corporation.
Loading paper for the paper roll supply module
1. Open the paper roll supply module. (See "Opening and Closing Modules and Other Parts"
on page 3-4.)
2. Remove the shaft, roll paper holder from the roll paper holder. (Since there are two
springs on the right and left sides of the shaft to keep it from being accidentally removed,
pull the shaft toward the groove on the paper holder to remove it.)
3. Attach a holder, roll paper which meets the inside diameter of the paper core to the shaft,
roll paper; then secure it with a C-ring.
Note:
At the default setting, the holder, roll paper A (for the 25.4 mm {1"}) inner diameter paper core) is
attached to the paper roll supply module. Since other holders are available as optional parts, use the
holder, roll paper that meets your paper core size. The holder, roll paper B is for a 50.8 mm
{2"} inner diameter paper core, and the holder, paper roll C is for a 76.2 mm {3"} inner diameter
paper core.
4. Load the paper roll to the holder, roll paper until it stops against the flange of the holder.
5. Facing the printing surface upwards, install the holder, roll paper to the roll paper
holder. After installing, make sure that the paper roll is secured by the two springs on both
sides.
Note:
Make sure that the paper roll is loaded with the printing surface facing upwards.
3-6 Handling Rev. A