Removing Jammed Paper From The Printer Module; Paper Ne Detector Setting - Epson EU-T432 Technical Manual

Thermal printer unit
Table of Contents

Advertisement

Confidential

Removing Jammed Paper From the Printer Module

1. Open the cut sheet presenter module.
2. Turn the lever, platen to open the platen unit and remove the jammed paper.

Paper NE Detector Setting

This detector is mounted on the paper roll supply module. By adjusting the position of the
detector, the detector can detect the amount remaining on the paper roll at the setting value. At
the default setting, the amount remaining is set to be about 5 m {196.85"} when the paper tip is
detected, and when using paper which has 25.4 mm {1"} inner diameter of the core, 33.4 mm
{1.3"} outer diameter of the core, and the 65 µm paper thickness. When you want to change the
setting, follow the steps below.
1. If the paper is loaded, open the paper roll supply module and remove the paper roll. (See
"Removing Paper" on page 3-9.)
2. Loosen the screw, NE detector so that the paper NE detector can be moved in the
direction of arrow in the illustration on next page.
3. Tighten the paper NE detector with the screw, NE detector at the position you want for
the paper NE detector.
The hole numbers for the paper NE detector fixing hole and the paper roll diameters
detected by the paper NE detector are as follows:
Table 3-1 Setting of the Paper NE Detector
Hole No.
40 mm
Detected paper
diameter
{1.56"}
(for 6 inch types)
40 mm
Detected paper
diameter
{1.56"}
(for 8 inch types)
Note:
Because the amount remaining on the paper roll will vary with the paper types (thickness), make sure
to check before setting.
Do not touch the light emission or receiving surfaces of the paper NE detector with your hands or
any objects since you may cause damage from dirt or static electricity.
3-10 Handling
Hole No.
Hole No.
1
2
3
50 mm
60 mm
{1.97"}
{2.36"}
50 mm
60 mm
{1.97"}
{2.36"}
Hole No.
Hole No.
Hole No.
4
5
70 mm
80 mm
90 mm
{2.76"}
{3.15"}
{3.54"}
70 mm
80 mm
90 mm
{2.76"}
{3.15"}
{3.54"}
Hole No.
Hole No.
6
7
8
100 mm
110 mm
{3.94"}
{4.33"}
100 mm
110 mm
{3.94"}
{4.33"}
Hole No.
9
120 mm
{4.72"}
Rev. A

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents