Pre-Assembly H: Cutting Sheet Presenter Module - Epson EU-T432 Technical Manual

Confidential

Pre-assembly H: Cutting sheet presenter module

Reassembly
Part name
step
1
Presenter roller assembly
Platen shaft holder
R.E (3)
C.B.S-tite (M3 × × × × 5)
Presenter frame, R/L
assembly
★
platen shaft holder
presenter frame,
right assembly
3 Spring, paper guide hold
presenter, frame, middle
presenter frame, right
assembly
6-44 Assembly and Disassembly
× 1
Attach a platen shaft holder to the presenter frame, right assembly from
× 2
inside while aligning its phase.
× 1
After attaching the R.E to the presenter roller assembly, pass the
× 2
assembly through the platen shaft holder on the presenter frame, right
assembly from inside.
× 1
After attaching a platen shaft holder to the other side of the presenter
roller assmbly, attach it to the presenter frame, left assembly.
;Attach the presenter frame, left assembly to the frame, presenter, middle
from inside and secure it with C.B.S-tite (M3 × × × × 5) screws.
< Check >
Tightening torque: 735 to 931 mN•m {7.5 to 9.5 kg•cm}
Lubricate the motor gear on the printer motor assembly with G-36.
presenter roller assembly
R.E (3)
Attach the spring, paper guide hold to the screw which secures the
× 1
presenter frame, right assembly and the upper side of the presenter,
frame, middle; then hook the longer leg of the spring to the hook on the
presenter frame, middle. (temporary attachment)
Assembly procedure
platen shaft holder
presenter frame,
left assembly
spring, paper guide hold
C.B.S-tite (M3 × 5)
Rev. A