Quantum DXi4510 User Manual page 83

Quantum DXi4000 User's Guide
Note: For help adding NAS shares to the system, use the NAS
Configuration Wizard (see
2 To configure the share to replicate its data to another DXi system,
enter the following information under Send:
a Select the Enable replication for selected share check box to
enable replication for the share.
b (Recommended) Select the Enable scheduled replication check
box to enable scheduled replication for the share.
Caution: A saved snapshot is necessary to recover your data
at a later time. For this reason, it is not enough to
simply enable replication for a share. You must also
configure a replication schedule (recommended) or
perform manual replication on a regular basis to
send snapshots of the share to the target system.
c If you enabled scheduled replication, select a schedule option
and specify the replication frequency:
• Daily at - Specify the time to replicate the share every day.
• Every - Specify the hourly interval at which to replicate the
share and the starting time.
d (Optional) Select the Enable Directory/File based replication
to target check box to enable Directory/File Based Replication
for the share, and then enter a Sync ID in the box.
With Directory/File Based Replication, a file is automatically
replicated when it is closed or a period of time after it is
modified. After replication, the replicated files are immediately
available on the target system.
The Sync ID is used to identify the target share that will receive
replicated data from the source share. The Sync ID
identical to the Sync ID of the target share on the target system.
3 To configure the share to receive replicated data from another DXi
system, enter the following information under Receive:
a (Optional) Select the Enable Directory/File based replication
to this DXi check box to enable Directory/File Based Replication
for the share, and then enter a Sync ID in the box.
Chapter 4: DXi4000 Configuration Wizards
NAS Wizard on page 44).
Replication Wizard
must
be
59