Quantum DXi4510 User Manual page 208

Chapter 9: DXi4000 Configuration
System
184
mode. The frame reception and transmission is controlled
by the LACP between the bonded ports and the Ethernet
switch ports.
c Click Update to update the Network page with the specified
bonding details. (Clicking Update does not yet apply the
changes to the DXi4000.)
Click Undo to revert to the previous bonding configuration.
4 Under IP Address Configuration > IP Address Table, enter
network information for each interface (physical Ethernet port or
bonded interface):
a Click Add New to add network settings for an interface.
Or select an interface to edit network settings.
b Enter the following network information as provided by your
network administrator (all fields are required):
• IP Address - The IP address of the interface.
• Netmask - The network mask of the interface.
• Gateway - The gateway IP address. (The gateway for a
directly connected interface is the IP address.)
• Use For Replication - Select to use this network interface
for replication traffic. You can select only one interface for
replication. If you do not select a replication interface, the
first available interface will be used for replication.
c Click Update to update the Network page with the specified
network settings. (Clicking Update does not yet apply the
changes to the DXi4000.)
Click Delete to remove network settings for the selected
interface. Or click Undo to revert to the previous network
settings.
5 Click Apply.
The grid in the Physical Ports Layout section displays the current
bonding scenario (see Physical Ports Layout on page 185).
Quantum DXi4000 User's Guide