Tatu Marchesan SDA CP Instruction Manual page 7

No-till seed drill
Table of Contents

Advertisement

TO THE OPERA
TO THE OPERA
TO THE OPERA
TO THE OPERA TOR
TO THE OPERA
- During the operation or transport do not allow riders on the tractor or
implement.
- Never allow children playing near the place that you are operating in, as
well as when transporting or stored.
- Learn about the area before starting the operation. Delimit the dangerous
places or the obstacles.
- Use the most appropriate speed according to the land conditions or roads
to travel.
- Use personal protective equipment for your own protection.
- Wear clothes and adequate shoes. Avoid large or loosen clothes that could
twine on the movable parts.
- Never operate without the machine protection devices.
- Be careful when hitching the implement to the tractor. Hands or fingers
can be injured when caught between the hitch and tractor drawbar.
- Before starting to raise or move the seeder check for people or animals
near or under the seeder.
- Verify with attention the transport width in narrow places.
- When disconnecting the implement move it to level area, preferably a hard
surface, on the field or at the warehouse. Certify that the machine is properly
stationed.
- See the general safety instructions in the back-cover of this Manual.
When Transporting the Implement on Truck or Trailer
To transport the equipment at long distances use a truck or trailer. However,
the safety instructions should be followed carefully:
- Use adequate loading dock to load and unload the equipment. Never use
a ditch bank, this practice could result in serious personal injury.
- In the event of lifting up with hoist use the appropriate points to hold.
- Use the seeder stands to prop it correctly.
- The seeder drawbar should be rised and locked in the vertical position or it
should be moved away and tied to the cargo.
- Tie the hopper covers and other mobile parts that can come unfastened
causing accidents.
- Use chock blocks and safety chains to secure the implement to the truck or
trailer during the transport.
- After 8 to 10 km transporting, please inspect the condition of the cargo.
Repeat this procedure every 80 to 100 km. Give more attention when
transporting the implement on rough roads, steep graders and other adverse
conditions.
- Be careful with transport height, specially when passing under electrical
power lines. Any contact could result in severe shock, injury or death.
- Observe all laws and regulations as to the height limits and cargo width while
transporting the implement on truck or trailer. If necessary use banners, lights
and other devices in order to give adequate warning to the drivers of other
vehicles.
TOR
TOR
TOR
TOR
6

Advertisement

Table of Contents
loading

Table of Contents