Table of Contents
Advertisement
SET
SET
SET
SET
SET -UP INSTRUCTIONS
Positioning the Row Units in the Chassis
Check whether the number of rows to be assembled in the machine is odd or
even and follow the instructions below:
Even Number of Rows:
Mark the center of the chassis and
measures half of the spacing to the right
and half to the left, fastening in these
points both first rows. From these rows you
mark the others with a spacing from each
other.
Left Rows
Note: - OBSERVE THAT THE ROWS ARE RIGHT
AND LEFT . SEE ILLUSTRATIONS AT SIDE.
- THE CENTRAL ROW ALWAYS MUST BE
LONG.
- THE SPRING HOLDER HAS THE FUNCTION
OF KEEPING UNIFORM SPACINGS OF 158
OR 175 MM BETWEEN ROWS. FOR THE
OTHER SPACINGS IT DOES NOT HAVE
ANY UTILITY.
- FOR LARGER SPACINGS JUST USE LONG
ROWS.
-UP INSTRUCTIONS
-UP INSTRUCTIONS
-UP INSTRUCTIONS
-UP INSTRUCTIONS
Right Rows
Left Rows
16
Odd Number of Rows:
Install a row unit in the center of the
chassis. From this row you mark the others
with a spacing from each other.
Spring
Holders
Right Rows
Advertisement
Table of Contents
