Table of Contents
Advertisement
MAINTENANCE
Ensure the tractor controls are in the park position, the engine is
turned off, the parking brake is engaged and hydraulic pressure
has been relieved before performing service or maintenance.
Always use personal protection devices such as protective glasses
and face shields, protective shoes, gloves, hard hats, and ear
protection when performing service or maintenance functions.
When completing a maintenance or service function, make sure all
safety shields are installed before placing mower in service.
LUBRICATION
A properly maintained lubrication schedule will provide a smooth
running machine for many years. Some pivot locations have grease
fittings.
The following information shows and describes where
lubrication points are located and what types of lubricant are required.
Service
Intermediate Hanger Bearing
Deck Pivots
Transport Wheels
Wing Pivots
Wing PTO Shaft (7 locn's each)
Input PTO Shaft (7 locn's)
Int. PTO Shaft (2 locn's)
Inspect Gearboxes
Check Gearbox Oil
Change Gearbox Oil
The TDR-30 blade spindles are factory equipped with maintenance free
sealed bearings as original equipment.
require manual greasing.
Never direct high pressure water spray at the blade spindles (top
or bottom). Water may enter the bearings and lead to premature
failure.
Lubrication Intervals
Initial Run -
Daily
As Req'd
50h
-
X
-
-
-
-
-
-
-
-
-
-
-
-
-
X
-
-
X
-
The blade spindles do not
TDR-30 Operator's Manual
100h /
600h /
Monthly
Yearly
-
-
-
X
-
-
X
-
-
X
-
-
-
X
-
-
X
-
-
X
-
-
-
-
-
X
-
-
-
X
39
Advertisement
Chapters
Table of Contents
