Progressive Turf Equipment TDR-30 Operator's Manual And Parts List page 43

TDR-30 Operator's Manual
INTERMEDIATE BEARING – 8h / Daily (1 Location)
Use only manual pump-style grease guns for lubricating
driveline components. Use of power greasing equipment can
induce excessive pressure into the component, compromising
sealing components and leading to premature wear and
component failure.
DRIVELINE GREASING
Driveline shafts on the TDR-30 mower feature a 100 hour grease
interval. The following decal located on the hose support shield as
a reminder of the minimum requirement.
INPUT & DECK SHAFTS – 100h / Monthly (7 / Shaft - 6 Shafts)
GUARD BUSHINGS CROSS & BEARINGS
CROSS & BEARINGS TELESCOPING SHAFT*
SPLINE
SPLINE
* Inner & outer guards must be rotated to align holes
for accessing telescoping shaft grease fitting.
Failure to properly lubricate the telescoping shaft sections will
lead to binding of the shaft and damage to the mower or
tractor driveline.
INTERMEDIATE SHAFT – 100h / Monthly (3 Locations)
CROSS & BEARINGS
SLIP YOKE SPLINES
GUARD BUSHINGS
41